ST Link V2 Programmer For STM8 and STM32

The ST Link V2 Programmer is designed for STM8 and STM32 and is manufactured with PCB installed inside of aluminum alloy U disk shell. This factory firmware ST Link V2 programmer has been upgraded to support the full range STM32 SWD and a full range STM8 SWIM. STLink V2 support the full range of STM32 SWD debugging interface using a simple 4-wire interface (including power).

It supports full range of STM8 SWIM download debugging (common development environments such as IAR, STVD, etc. are supported). ST-Link V2 Programmer is fully consistent with the official version, support for automatic upgrades, support the full range STM32 SWD (only 4pins including SWCLK, SWDIO, and power) and a full range STM8 SWIM (only 4pins including SWIM, Reset and power) download and debug.

Use this device to send program code to the 32-bit STM32 ARM Cortex or 8-bit STM8 microcontrollers. The header for this ST-Link v2 programmer contains connections for 5V, 3.3V, SWCLK, SWDIO, SWIM, Reset (RST/NRST), and GND. The connector on the opposite side of this device is a USB connector and is intended to be plugged into the computer.

Features:

• Programmer/Debugger For: STM8 and STM32
• SWD and serial wire viewer (SWV) communication support
• Status LED blinking during the communication with the PC
• Output Voltage: 3.3V/5V
• Interface definition directly marked on the shell
• Internal motherboard with 500MA fuse for self-recovery
• Direct firmware update support (DFU)
• Operating temperature from 0 °C to 50 °C

Country of origin : China

• 1 x ST-Link V2 Programmer
• 4 x Connecting Wires