Tactile Push Button Switch Module

This Tactile Push Button Module DC 5V 12V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module of the push button is a fully-fledged device with which you can install it immediately in the project, without using a pull-up or tightening resistances, because this is already in the circuit. The button together with the resistor is located on the board, where there are holes for installation. The built-in resistor has a rating of 10 kΩ.

The module is designed for two contacts: when pressed, they are closed and open when released. There are also 3 outputs on the board: I, S, +. Contact I (Middle) is connected to the common wire of the circuit, S is the output of the module and + is connected to the power supply.

Features:

• On board 10KΩ Resistance
• Can work with 3.3V ~ 12V Power supply
• 3 Pins with 2.54mm pitch for easier connectivity

Country of origin : China

Note:Header pins are already soldered to the module

1x Tactile Push Button Switch Module